It is true that automatic garage doors are very practical. However, it is inevitable that from time to time a problem or another will arise. That is why in this article we want to tell you about the most frequent breakdowns in automatic garage doors, so that you can recognize the problem and solve it.
Garage doors mechanisms generally offer a high degree of reliability. In fact, more and more effort is being put into making quality and durable products.
However, there are certain factors that will necessarily affect the garage doors, such as continued use or weather conditions.
Most frequent breakdowns in automatic garage doors
Sometimes the door does not work, but it is difficult to find out the reason for the failure. For this reason, below we want to explain what are the most frequent breakdowns or failures in automatic garage doors.
The garage doors won’t open
It is one of the most typical breakdowns and, in particular, there are two very common reasons:
A problem with the control that operates the door. Believe it or not, sometimes the explanation is as simple as that the remote has run out of batteries. Check that the remote does indeed have a battery. If it is charged and still does not work, it may be faulty. In this case, it is best to contact a professional to verify that it does not work and repair it with all the guarantees.
A failure of the signal receiving device. As with the remote, only an expert can perform the repair. However, there is a possibility that it is not damaged and that it is an interference that prevents the waves from reaching. Most garage remotes have a control box. To check if the problem is interference you can use the input button in this box.
You should also check that the motor electronic board is turned on. If so, check that the focus of the problem is not any of the accessories, such as the photocells. Unplug them one by one to discard them.
If the electronic board is off, check the status of its fuses.
Another cause can be a loose cable or a bad connection. These types of breakdowns can be caused by the engine’s own vibrations. For this reason, it is important that, at the time of installation, all the wiring is hidden and safe.
In any case, before checking the wiring, take precautions and cut the power. You must follow the following steps:
Review the entire installation
If the problem is a stud that has come loose, it’s as easy as re-tightening it.
On the other hand, if there is a broken or disconnected cable, it will be necessary to make a splice or replace what has been damaged.
You may not have the necessary notions to carry out this work. If you have any minimal doubts, contact a professional, since these facilities are delicate and it can be dangerous to manipulate them if you do not have experience.
The garage doors won’t open or close
This situation can occur due to a failure in the control or in the receiving device, but there may also be a problem with the mechanism that moves the door. Most likely it is clogged.
It is essential that you do not try to force the door, as it could make the problem you are trying to solve worse.
The correct way to proceed is to carry out proper maintenance and clean the guides and rails from the first moment you notice that the door does not slide as well as it should. In many cases, these problems are aggravated because they are not solved in time.
In the most serious traffic jams, it is necessary to remove the garage door to be able to remove the obstacle that is obstructing it. Here are some tips to do it on your own:
Always maintain a certain order to disassemble and reassemble the door. You can write everything down to make sure you don’t forget the steps you are following.
Store the small pieces in a closed container so you don’t lose any
You can take advantage of it to lubricate the parts if you want to get a smoother bearing.
On the other hand, you may need to repair your garage door because it neither opens nor closes completely. The first thing is to check the switching times set, and also can review the limit switches.
Again, our advice is that you contact a professional if you are not completely sure that you can perform the task on your own.
Taking the risk without having the necessary skills can end with an even worse breakdown or even an accident, so it is not recommended at all.
Another article on this blog that might interests you: